KVH Industries TracVision TV1 Installation Manual page 28

16 Continued
Setup Wizard
System configuration continues by prompting
you to enter information or perform specific
tasks, as necessary. For example:
• Enter installer and vessel information
• Select a source for GNSS position data
• Select a source for heading data (if NMEA
device is connected)
• Select the satellite TV service
• Select satellite(s) to track (make your own
selections or select one of the preset groups
listed in Figure 45), or create user-defined
satellites
• Set up automatic switching, if applicable
Additional Setup Information
Once the Setup Wizard has been completed,
perform follow-up tasks such as:
• Set up receivers to operate with the system
(as instructed by the Wizard)
• Activate the receivers (as instructed by the
Wizard)
• Set the antenna's LNB to the skew angle
provided by the Wizard (see
Skew Angle" on page
systems only)
Set Up the System
"Set the LNB
29; applies to linear
Figure 45: Preset Satellite Groups
Service Satellites (A-B-C-D)
Linear Create a custom group if
multiple satellites are needed
DIRECTV U.S. DIRECTV Dual:
101W and 119W
DISH Western Arc:
Network 110W, 119W, 129W
Legacy East Arc:
61W, 110W, 119W
DISH 500:
110W, 119W
Bell TV No preset groups supported, but
compatible with 91W
Note: This list is subject to change.
27