KVH Industries TracVision TV1 Installation Manual page 22

11 Continued
Connect Power to the System
NOTE: When powering up a SWM configuration,
apply power to all other system components before
powering up the receivers and DVRs (tuners are
assigned SWM channels during startup).
Follow the steps below to connect power to the
TracVision system (see Figure 34).
IMPORTANT!
All power connections must be hard wired.
a. Make sure that the ground wire from the
TV-Hub has been connected as described on
the previous page.
b. Connect the TV-Hub power cable (supplied
in the kit) to the 10-30 VDC power input on
the rear of the TV-Hub.
c. Connect the black wire of the TV-Hub power
cable to ship's ground.
d. Connect the red wire of the TV-Hub power
cable to the vessel's 12 VDC or 24 VDC power
source (10-30 VDC is required at the
TV-Hub).
NOTE: An optional 24 VDC AC-DC power supply
(5 A, 120 W) is available from KVH (part no.
72-0669).
Connect Power
Figure 34: TracVision System Power
Input
Filter
Black
Fuse Holder with
Red
9A 32V SFE Fuse
21