Installation Procedure - Toshiba RAS-10N3KVR-E Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units
8
(
Flat head
Battery cover
wood screw
&
Flat head
wood screw
3
Batteries
The provided Remote Controller is a
wireless type, which also can be used
as a wire.
Please see "How to Connect The Remote
Controller for Wired Operation", in case of
wired control is required.
Remark :
•
Detail of accessory and installation
parts can see in the accessory sheet.
• Some pictures might be different from
the actual parts.
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (- ) positions.

10. INSTALLATION PROCEDURE

6
Filter
8
5
Filter
Flat head
wood screw
2
Wireless remote control
Before installing the wireless remote controller
Hook
1
Installation
plate
Shield pipe
4
Remote control holder
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension
drain hose
(Not available,
provided by installer)
2 Wireless remote controller
– –
52
FILE NO. SVM-12057
For the rear left and left piping
Wall
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Left
Bottom Rear
right left
Bottom left
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
3 Batteries