Quiet Mode; Comfort Sleep Mode; Short Timer - Toshiba RAS-10N3KVR-E Service Manual

Item

16. QUIET mode

When the [QUIET] selected form [Fan] button, the
fan of the indoor unit will be restricted the revolving
speed at speed L
other speed (cancel Quiet mode).
17. COMFORT
Cooling mode
SLEEP
• The preset temperature will increase as
show on ECO operation (Item No. 9)
• Press the [COMFORT SLEEP] button to
choose the operating hours. Repeat
(1hr, 3hr, 5hr or 9hr)
• If the [COMFORT SLEEP] button is pressed
again means cancel comfort sleep mode.
Heating mode
• The preset temperature will drop down as
show on ECO operation (Item No. 9)
• Press the [COMFORT SLEEP] button to
choose the operating hours. Repeat
pressing to setect thehours.
(1hr, 3hr, 5hr or 9 hr)
• If the [COMFORT SLEEP] button is pressed
again means cancel comfort sleep mode.

18. Short Timer

In the normal condition, after switching one circuit
breaker, 3-minute delay time for compressor and
1 hour for plasma air purifier are set for the
maintenance of the unit.
Operation flow and applicable data, etc.
−
until the [Fan] button is selected
pressing to select the hours.
SWING FA N
ONE-TOUCH FIX QUIET
PURE Hi POWER
COMFORT
SLEEP
Quiet mode is the system which, control the
revolving speed of indoor fan to work
constantly at lower than speed L. In addition,
noise level of indoor unit is less than usual.
Remarks :
1. Quiet mode is unable to work in dry mode.
2. Quiet mode is appropriate to work with less
cooling load and less heating load condition.
Because of the fan speed L- may cause not
enough the cooling capacity or heating
capacity.
The principles of comfort sleep mode are:
• Quietness for more comfortable. When
room temperature reach setting temperature
• Save energy by changing room temperature
automatically.
• The air condition can shut down by itself
automatically.
Remarks:
1. Comfort sleep mode will not operate in dry
mode and fan only mode.
Purpose
To start the unit immediately for the purpose of
testing, trial...etc, short timer can be used.
maintenance of the unit.
Short Timer Setting
j
k
Set the operation mode or plasma air
purifier on the remote control without
sending the signal to the unit.
l
Use the tip of the pencil to push the
[CHK] button and hold, "00" will show
2
m
n
When short timer is activated, all
setting on the remote operates
1
− 44 −
FILE NO. SVM-12057
Description
Press [ ] button to turn the unit OFF.
on display, them press [SET] button
to make "00" disappear.
Press [ ] button to turn the unit ON.
immediately, besides, all indicatiors on
front panel turns ON continuously for
3 seconds.