Indoor Unit - Toshiba RAS-10N3KVR-E Service Manual

10-3. Indoor Unit

10-3-1. Installation Place
• A place which provides the spaces around the
indoor unit as shown in the diagram.
• A place where there are no obstacle near the air
inlet and outlet.
• A place which allows easy installation of the piping
to the outdoor unit.
• A place which allows the front panel to be opened.
• The indoor unit shall be installed as top of the
indoor unit comes to at least 2 m height.
Also, it must be avoided to put anything on the top
of the indoor unit.
CAUTION
• Direct sunlight on the indoor unit wireless
receiver should be avoided.
• The microprocessor in the indoor unit should
not be too close to RF sources.
(For details, see the owner's manual.)
<Remote control>
• A place where there are no obstacles such as curtain
that may block the signal from the indoor unit .
• Do not install the remote control in a place
exposed to direct sunlight or close to a heating
source, such as a stove.
• Keep the remote control at least 1 m apart from
the nearest TV set or stereo equipment.
(This is necessary to prevent image disturbances or
noise interference.)
• The location of the remote control should be
determined as shown below.
(Side view)
(Top view)
Reception
Remote
range
controller
Fig. 10-3-1
Indoor unit
Reception
range
Remote controller
10-3-2. Cutting a Hole and Mounting
Installation Plate
<Cutting a hole>
When installing the refrigerant pipes from the rear.
1. After determining the pipe hole position on the
mounting plate (A), drill the pipe hole (∅ 65 mm) at
a slight downward slant to the outdoor side.
NOTE :
• When drilling a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
<Mounting the installation plate>
Anchor bolt holes
170
85
Hook
Pipe hole
Indoor unit
– –
56
FILE NO. SVM-12057
100 mm
Fig. 10-3-2
Hook
Hook
Thread
Pipe hole
7
Weight
Mounting screw
Fig. 10-3-3
Pipe
hole
∅65 mm
62
82.5
1
Installation
plate