2-10. Removing/Installing the AC/DC Converter
2-10. Removing/Installing the AC/DC Converter
1. Remove the FL-249 board referring to Section 2-9.
2. Remove the two screws (B2.6 x 5) securing the AC/DC converter.
3. Disconnect CN7 on the CN-1438 board while lifting the AC/DC converter.
4. Install in the reverse order of removal.
[Note|at|installation]
[Note|at|installation]
[Note|at|installation]
[Note|at|installation]
[Note|at|installation]
After connecting the harness extending from the AC/DC converter to CN7 on the CN-1438 board,
route the harness as shown in the figure.
AC/DC converter
2-10 (E)
CN-1438 board
Unlock and disconnect in
the direction of arrow
B2.6 x 5
CN-1438 board
B2.6 x 5
< Harness routing >
CN7
< Step 3 >
CN7
CA-570 P1