Sony IPELA PCS-G50 Technical Documentation Manual page 7

Integration with Sony Network Camera
©2008 Sony Corporation
When a connection to a network camera is made using the administrator
authority, the modes described below will automatically be changed.
• Audio Codec
If the audio codec setting (used to send audio) of the network camera is G.726, it
will automatically be changed to G.711.
• Audio (Bidirectional)
If the audio upload setting of the network camera is disabled, it will automatically
be enabled to perform voice communication from the video communication
terminal to the network camera. If the microphone setting of the network camera is
OFF, it will automatically be turned ON to perform voice communication from the
network camera to the video communication terminal as well.
• Multicast Streaming
If the multicast streaming setting of the network camera is OFF and the connection
is made through UDP (Multicast), multicasting will automatically be turned ON for
the connection using UDP (Multicast).
• Unicast Streaming
If the network camera's unicast streaming setting (video or audio port number)
overlaps with the port number used by the PCS-G50/G70, it will automatically be
changed to another number for connection.
Operating with User Authority in PCS Integration
You cannot change the network camera setting items through the PCS-G50/G70.
You must use the network camera to configure settings related to the connection
with the PCS-G50/G70. (Settings configured through the Network Camera page in
the PCS's General Setup menu will be disabled.)
To use the camera control and preset functions via the PCS-G50/G70, you must
properly configure the network camera's User menu. (See Table 1.)
VIDEO COMMUNICATION SYSTEM - TECHNICAL DOCUMENTATION
February, 2008 / Ver 1.0 7