Customer Set Relocation; Data Security - Samsung OfficeServ 7200 General Description Manual

Split
A keyset user can "split" a conference into separate outside calls, then speak with each caller privately. Then
the individual calls can be conferenced again in any combination. NOTE:This feature requires individual trunk
buttons and auto-hold must be enabled.
CONFERENCE GROUP
Users that have a 5012L-ITP large screen keyset or OfficeServ Softphone may have 1-5 conference groups
programmed. Each conference group can have up to 4 parties assigned. They can be extensions in the sys-
tem or telephone numbers of people outside the system. Press the Conference Group button to call all mem-
bers of the group at the same time. Status indications appear in the display. Press the corresponding softkey
to drop or call parties as desired (maximum 100 users).

CUSTOMER SET RELOCATION

Customer Set Relocation allows the customer to exchange or swap similar stations in the OfficeServ 7200
without wiring changes. All individual station assignments such as trunk ring, station group, station COS, sta-
tion speed dial, button appearances, call forwarding, etc. will follow the Customer Set Relocation program.

DATA SECURITY

Single line extensions used with modems and facsimile machines can be programmed so that they will not
receive any system-generated tones that would disrupt data transmissions. In addition, these devices receive
DCS C.O. ringing pattern instead of intercom ring pattern. Devices connected to an SLI card receive a discon-
nect signal upon termination.
DATABASE PRINTOUT
A copy of the customer database can be obtained by using OfficeServ™ Manager (OSM).This information can
be directed to a printer or the PC screen and may be done either on-site or remotely. A complete database or
specific data blocks may be obtained.
DAYLIGHT SAVING TIME-AUTOMATIC
The system has a table that can be programmed with the daylight savings change dates for up to 10 years.
At 2:00 am on these dates the system will automatically adjust the system clock to match daylight savings
time. If no dates are programmed the clock will not change.
DIALED NUMBER IDENTIFICATION SERVICE (DNIS)
When DNIS service is provided on an incoming E&M trunk the OfficeServ 7200 can route calls based on the
numbers received. (See DID)
DIRECT IN LINES
Outside lines may be programmed to bypass the operator(s) and ring directly at any station or group of sta-
tions.
DIRECT INWARD DIALING (DID) (T1 or ISDN PRI Service Only)
The term Direct Inward Dialing refers to types of digit steered inbound call handling.These are DID, Both Way
DID, Dialed Number Identification service (DNIS) and Direct Dial In (DDI). The OfficeServ 7200 supports the
types described below.
DID is an inbound only service where multiple telephone numbers are assigned, usually in blocks of twenty,
4.14