Installation; Preparing For Intelligent Stack - InFocus IN5132 User Manual

2. Installation

For safety reasons, read
installation. In addition, review the following for proper use of Instant Stack.
• Use the same model projectors.
• Arrange the projectors side by side.
• Verify the projection screen is perpendicular
to the projectors.
• Project images larger than the minimum
screen size shown in the table. The greater the
distance between the projectors, the larger the
screen size needs to be.
L: distance Minimum screen size
[cm]
30
50
100
● If you control one projector with the remote control during installation, we recommend
that you operate the other with the control panel or a wired remote control. In this case,
disable the remote control receiver on the other projector with the KEY LOCK feature.
(Operating Guide
● Images from Set A and Set B may superimpose well but the image positions can shift
over time. Readjust to superimpose the images.

2.1 Preparing for Intelligent Stack

When using Intelligent Stack via an RS-232 connection, ensure the following
settings are set up on the two projectors. Otherwise, the Intelligent Stack menu
cannot be selected.
● STANDBY MODE in SETUP menu: NORMAL
(Operating Guide
● COMMUNICATION TYPE under COMMUNICATION in SERVICE menu: OFF
(Operating Guide
● STACK LOCK in SECURITY menu: OFF
When STACK LOCK is set to ON, menus related to Instant Stack cannot be
selected. Therefore it is necessary to turn STACK LOCK to OFF during Instant
Stack installation and menu set up.
(1) Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > SECURITY (> ENTER PASSWORD)
> STACK LOCK
STACK LOCK dialog will appear on screen.
Guide → SECURITY
(2) Use the ▲/▼ buttons to highlight OFF, and press the ► button to save the
setting.
1.1 Basic information and preparations
[inch]
200
250
380
→
OPTION menu)
→ SETUP menu)
→ OPTION menu)
menu)
Screen
size
L (30cm or more)
(Operating
5
( 3, 4 ) carefully before
Projector
0 ± 10cm