Reconfiguring To Factory Settings; To Reconfigure The Mes1A To Factory Settings; To Reconfigure The Mes1B, To Factory Settings; Network/Ip Settings - B&B Electronics MES1A User Manual

RECONFIGURING TO FAC TORY SETTINGS
The MES1A and MES1B come from the factory preconfigured for correct operation
with their respective interfaces. The following procedure describes how you can
return the MES1A and MES1B to their original factory settings.

TO RECONFIGURE THE MES1A TO FACTORY SETTINGS:

Type D at the Select Command or parameter set (1..4) to change: prompt. The
Configuration Menu is updated with the new settings displayed.
TO RECONFIGURE THE MES1B, TO FACTORY SE TTINGS:
14. Type D at the Select Command or parameter set (1..4) to change:
15. Type 2 to enter the Serial & Mode Settings section and set the
16. Type 3 to enter the Modem/Configurable Pin Settings section and

NETWORK/IP SETTINGS

In the Network/IP Settings section of the Configuration Menu you can configure:

IP Address of the MES1A/B

Default Gateway

Netmask

Telnet Configuration Password
prompt.
Serial Mode for RS-485 Two-Wire (see the next section for details).
set CP1 to RS-485 Enable Wire (see the next section for details)..
See the following sections for details on how to set
Serial & Mode Settings and Modem/Configurable
Pin Settings.
30