GE 20 kW Home Installation And Start-Up Manual page 39

Wireless Monitor operation
1. Remove battery access cover (A) on back of monitor
and install 2 AA batteries. (Observe correct battery
polarity which is embossed in the bottom of the
generator ready
battery compartment). Replace battery access cover.
generator power
service needed
system update
DEALER NAME
DEALER PHONE
NOTICE The wireless monitor was linked to the generator at
the factory. Communication will begin upon the installation
of the batteries and the generator being placed in AUTO
mode. You may need to press System Update one time.
2. The wireless monitor does not have an on/off
switch. When batteries are installed correctly,
the GENERATOR READY green LED light will flash
once every 7 seconds indicating the status of the
generator.
NOTICE If communication does not begin upon placing the
generator in AUTO, installing batteries, and pressing System
Update, the monitor may need to be re-linked. To link, follow
Steps 3 through 6.
3. Locate the MENU AND ESCAPE buttons on the control
panel (B) . Press and hold for 3 seconds to enter the
B
linking mode.
B
B
a
# of flashes service needed
1 low battery voltage 5 low frequency
2 low uid level 6 engine overspeed
3 under/over voltage 7 high temperature
4 engine does not start 8 transfer switch
part #: 316196 fcc id: MCQ-XBS2C IC id: 1846A-XBS2C
a
menu
ok
esc
auto off manual
4. "LINKING MODE" will scroll across the generator
control panel.
5. Locate and hold the SYSTEM UPDATE button (C) on
the wireless monitor for 5 seconds. All 3 LEDs will flash
until the monitor links to the generator. Once it links,
the monitor will display the current state. The monitor
will try to link for 1 minute. (This step can only be
completed when the generator is in Linking Mode).
c
6. Once the link has been confirmed, press the OK
button on the generator control panel to exit or the
control board will turn off linking after 5 minutes. The
generator will now communicate with the wireless
monitor.
NOTICE It may take up to 1 minute for the monitor to begin
displaying the generator status correctly.
c
generator ready
generator power
service needed
system update
DEALER NAME
DEALER PHONE
39