6.
Reconnect the system to the electrical outlet and turn the system on, including any attached
peripherals.
Figure 18. Removing and Installing the PERC H310 Card Riser
1.
PERC H310 card riser
3.
guide pins (2)
Installing The Dell PERC H310 Card Riser
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Align the PERC H310 card riser with the connector and the guide pins on the system board.
2.
Lower the PERC H310 card riser into place until the PERC H310 card riser is fully seated in the
connector.
3.
If applicable, reinstall the PERC H310 card into the PERC H310 card riser.
For more information, see
4.
Close the system.
5.
Reconnect the system to the electrical outlet and turn the system on, including any attached
peripherals.
6.
Install any device drivers required for the card as described in the documentation for the card.
System Battery
Replacing The System Battery
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer. See your
safety information for additional information.
Installing A Dell PERC
H310.
2.
release tab
4.
PERC H310 card riser connector
43