Dell DL1000 Owner's Manual page 29

NOTE: The procedure to install a 3.5 inch HDD0 and HDD1 cage is identical.
1. If installed, remove the front bezel.
2. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet
and from the peripherals.
3. Open the system.
4. Align the slots on the hard-drive cage with the standoffs on the chassis. Slide the hard-drive cage
toward the chassis wall until it snaps into place.
NOTE: For the 3.5 inch HDD0 cage, the slots are under the hard-drive cage.
5. Connect the power and data cables to the Dell PERC H310 card cable adapter.
6. Connect the PERC H310 card cable adapter to the hard drive.
7. Close the system.
8. Reconnect the system to the electrical outlet and turn on the system and attached peripherals.
9. Enter the System Setup and ensure that the hard drive's controller is enabled.
10. Exit the System Setup and restart the system.
11. Install the software required for the hard drive operation as described in the documentation for the
hard drive.
29