Tailwheel Assembly (Figure Asm-0002); Front And Rear Deflectors (Standard Equipment) And Chain Guards (Optional Equipment At Extra Cost) - RHINO TW60 Operator's Manual

Tailwheel Assembly (Figure Asm-0002)

To assemble the Mower's TailWheel, follow the procedures listed below. Note: Certain steps may have been
performed by the manufacturer before delivery.
1. Place a 1-1/2" flatwasher (3) on the shaft of the
caster fork & wheel assembly (5).
assembly to tailwheel beam (1) by inserting
shaft through the large hole of the tailwheel
beam. The beam must be positioned with its
grease fitting on the opposite end of the
tailwheel. Note: A light coat of grease can be
placed on the shaft for easier installation. After
the shaft is completely inserted, place another
1-1/2" flat washer onto the shaft and retain by
inserting a cotter pin (4) through shaft above
the washer. Spread ends of cotter pin..
2. Slide tailweel positioning bracket (2) onto
tailwheel beam. Position the opposite end of
the tailwheel beam between the set of lugs in
the mid section of the mower deck behind the
gearbox. Align holes of the lugs and tailwheel
beam and retain with a 5/8" x 4" bolt (7) and 5/
8" locknut (6).
3. Place the mid section of the tailwheel beam
between the tailwheel beam support brackets at
the desired cutting height. Note: The rear deck
height is set by raising or lowering the tailwheel
beam. Raise the beam to reduce the height of
cut, lower the beam to increase the height of
cut. Retain the beam in this position by
securing the positioning braket to support
braces with two 1/2" x 1-1/2" bolts (8) and 1/2"
locknuts (9).
4. Tighten all bolts, lockwashers, and nuts to the
recommended torque and grease fitting on end
of tailwheel beam until grease is visible on
either end of shaft.
Front and Rear Deflectors (Standard Equipment) and Chain Guards
(Optional Equipment at Extra Cost)
Front and Rear rubber-fabric Deflectors are Standard Equipment and Front and Rear
Chain Guards are optional . One type of guard must be installed (and maintained in good
repair) except for agricultural purposes only in areas where persons, vehicles, livestock, or
other property will not be endangered by thrown objects and where such safety equipment
would prevent the mower's reasonable performance of its assigned agricultural task.
Assy01-Shielding
TW6072 05/05
© 2005 Alamo Group Inc.
ASSEMBLY
Attach
Assembly Section 3-3