Table of Contents
Advertisement
Step 5 Mode Setup
5-1 Setting in the MODE SETUP screen
Select mode of the unit according to the system of use.
1.
Click Mode Setup in the Network Codec screen
•
The MODE SETUP screen is displayed.
Click "Detailed Setup" to display
submenus.
Select the mode according to the system of use.
Mode
Camera
Camera side of remote monitoring system (
Monitor
Monitoring side of remote monitoring system (
Teleconference
Teleconference system (
ISMA Server
Streaming system (
User Mode
Values changed in "Step 6 Detailed Setup" are saved.
Name of the mode will be "User_Mode_Camera", etc. It means user defined mode
changed from Camera mode.
* The following screen appears on the Browser after performing changes, and the number display of the unit
will show a circling display.
Memo
•
When the mode is changed, the unit will restart and all settings will return to their initial values of each mode.
•
If the current mode is "User Mode", "User Mode" can not be deleted even when clicking "Delete User
Mode". Do not click "Delete User Mode" during "User Mode".
•
Only one "User Mode" can be saved.
Cautions concerning setting changes
•
Settings can not be changed when the unit is communicating with other units. Warning page is displayed on
Web browser if you try to chang settings during communication.
•
In such case, stop all communications with other units.
•
To check current communications, refer to "Telnet Settings" on page 54 and execute the "stat" command.
System of use
see page 13)
see page 15)
and
(Be sure to perform)
1
Select the mode.
(Factor y setting: CAMERA
mode)
2 Click "Initialize to Preset Values"
to reset to the initial values of the
mode selected in
1
Memo
When clicking this button, the
HOLD display lamp will turn on and
panel operations will be locked.
3 Click "Delete User Mode" to
delete the user mode.
4 Click "Save User Mode" to
register the current settings as
the user mode.
see page 14)
see page 14)
are displayed
.
29
Advertisement
Table of Contents
