Table of Contents
Advertisement
Back
AC IN
@2
0 Connection number display
While in the Teleconference or Monitor mode, the con-
necting destination number is displayed. The display
will flash when establishing connection and the lamp
will change to a constant display when connection is
established.
While in the ISMA mode, the number of streams trans-
mitted is displayed.
A CF card slot
CF card can be inserted after removing the screw.
(
See "Inserting a CF Card", page 17)
B RXD display lamp
The lamp turns on when data is being sent/received
via the C 100BASE-TX terminal.
C [100BASE-TX] 100BASE-TX terminal
100BASE-TX terminal for connecting a LAN cable.
(
See "Connecting a LAN Cable, page 17)
D LINK display lamp
The lamp turns on when the 100BASE-TX terminal is
ready for communication.
E [75 /OPEN] Input 2, 75 terminal switch
75 terminal switch for the F VIDEO IN 2 terminal.
Select "OPEN" during loop-through connection. Other-
wise, select "75 ". Video may not be displayed cor-
rectly if the switch is not set properly.
(Factory setting: 75 )
F [VIDEO IN 2] Video input terminal 2
Input terminal 2 for video signal. Used for inputting video
signal from a camera, etc.
ALARM
RS485
RS232C
AUDIO
VIDEO
VIDEO
IN
OUT
OUT
IN 1
L
R
RESERVED
@1
@0
!9
!8
G [75 /OPEN] Input 1, 75 terminal switch
75 terminal switch for the H VIDEO IN 1 terminal.
Select "OPEN" during loop-through connection. Other-
wise, select "75 ". Video may not be displayed cor-
rectly if the switch is not set properly.
(Factory setting: 75 )
H [VIDEO IN 1] Video input terminal 1
Input terminal 1 for video signal. Used for inputting video
signal from a camera, etc.
I [VIDEO OUT] Video output terminal
Output terminal for video signal.
Used only when in the Teleconference or Monitor mode.
J [AUDIO OUT] Audio output terminal
Output terminal for audio signal. Used for connecting
audio input terminal of a monitor, etc.
Used only when in the Teleconference or Monitor mode.
(RESERVED: Currently cannot be used)
K [AUDIO IN L/R] Audio input terminal
Input terminal for audio signals.
L and R channels can be used when in the ISMA mode.
The L channel terminal can be used when in the tele-
conference or Monitor mode.
L [AC IN] AC power input terminal
Input commercial AC120V using the included power
cord.
(
SERIAL 1
SERIAL 2
SERVICE
CONTROL
VIDEO
IN 2
LOOP
LOOP
100BASE-TX
THRU
THRU
OPEN
OPEN
!7
!6
!5 !4 !3 !2
See "Connecting the Power Cord", page 19)
9
Advertisement
Table of Contents
