1-2 Connecting a LAN Cable
Connect the unit to a hub or a PC using a LAN cable. For the cable, select category 5 or higher.
ALARM
SERIAL 1
RS485
RS232C
DIO
VIDEO
VIDEO
OUT
OUT
IN 1
LOOP
THRU
OPEN
RESERVED
1-3 Inserting a CF (Compact Flash) Card
JPEG images can be saved to a CF card. Insert a CF card by following the steps shown below.
Note
Always turn off the power when inserting/removing a CF card. Inserting/removing the card with the power on may
cause damage to the recorded files of the card or the card itself.
* For detailed setup concerning the CF card,
SERIAL 2
SERVICE
CONTROL
VIDEO
IN 2
LOOP
100BASE-TX
THRU
OPEN
EJECT button
see "CF CARD SETUP screen", page 41.
When connecting to a hub:
Use a straight cable.
When connecting to a PC:
Use a cross cable.
Note
Please check the specifications of the LAN board
of the PC since in rare cases the use of a cross
cable may not be supported.
1.
Remove the cover
If the mounting screw is difficult to turn,
use a hexagonal wrench (bolt width:
2.5mm).
2.
Insert a CF card
Make sure the top side is facing up and
insert the card securely.
3.
Collapse the EJECT button
4.
Reattach the cover
17