Maintenance Page - JVC 4ch Network Encoder VN-E4 Instructions Manual

Settings
(continued)

5-13 Maintenance Page

This page is for maintenance purposes.
A
B
C
This page can be used upon access via AadminB.
A A/V Settings
B All Settings
C Update
Progress Status
Uploading file
Start FLASH writing
FLASH writing 1/3 completed
FLASH writing 2/3 completed
Rebooting
Startup completed
A message will be displayed on the Internet Explorer when update is successfully completed. Network settings will be saved upon
updating the firmware, but all other settings will be initialized.
36
Restores setting items in the AInputB page, AEncodingB page and AMotion DetectionB to their
default values.
JPEG or audio transmissions that are in progress will continue if these are possible with the
factory settings.
Restores all setting items to their default values and reboots the unit. Passwords will also be
initialized. However, the built-in clock of VN-E4 will not be affected. JPEG transmission and all
other services that are running is terminated.
(A pg. 37, AInitial Values of Each PageB)
For updating the firmware of VN-E4. Copy the new firmware file to the PC on which Internet
Explorer is used, and specify this file using the ARef...B button.
Press the AUpdateB button to start updating. Update may take several minutes. Update progress
status is indicated on the lamp at the front panel of VN-E4.
STS
Light ON
Light ON
Light ON
Light ON
Light OFF
Light ON
Ref...
CH1 CH2
Blinking Light OFF
Light ON Blinking
Light ON Light ON
Light ON Light ON
Light OFF Light OFF
Light OFF Light OFF
CH3 CH4
Light OFF Light OFF
Light OFF Light OFF
Blinking Light OFF
Light ON Blinking
Light OFF Light OFF
Light OFF Light OFF