JVC 4ch Network Encoder VN-E4 Instructions Manual page 22

Settings
(continued)
A Switching Language
B Reload Button
C Viewer... Button
22
Click AJapanese / EnglishB at upper right to switch the display language of the web page.
Press this button to refresh the JPEG image displayed.
Clicking AJPEG ViewB or re-entering the Internet Explorer address will only display the page that
is temporarily stored in the Internet Explorer, and JPEG images may not be refreshed in this
case. To refresh JPEG images using the above operations, change the Internet Explorer settings
as follows.
Open AToolsB - AInternet OptionsB, and click the ASettingsB button under Temporary Internet Files.
Select AEvery visit to the pageB.
This is displayed upon access to the AJPEG ViewB page via AadminB or AoperatorB. Click this
button, and click AOKB button on displayed security alarm window to launch the built-in viewer.
Do not click this button again leaving the security alarm window. The motion detect setting
window on the AAlarm EnvironmentB page and the built-in viewer cannot be launched at the
same time.
When this button is pressed for the first time on the operating PC, the built-in viewer will be
installed on the PC. Refer to ASTART-UP GUIDEB on procedures to install the built-in viewer on
the PC. Refer to ASTART-UP GUIDEB on basic operations of the built-in viewer. Refer to A6. Using
the VN-E4 Built-in ViewerB on further details on the uses of the built-in viewer.
A
B
C