Serial Page - JVC 4ch Network Encoder VN-E4 Instructions Manual

Settings
(continued)

5-6 Serial Page

This page is for setting the 2 serial ports.
A
B
C
D
E
F
This page can be used upon access via AadminB or AoperatorB.
Press the AOKB button to enable the new settings upon changing. If the AOKB button is pressed upon entering an invalid value, a
warning message will appear and entry will be denied. Press the ACancelB button to restore the invalid entry to the current value.
A Controlled Device
B Baud Rate
C Data Length
D Parity
E Stop Bit
F Comment
Select a device accordingly when an external device is to be controlled using the built-in viewer.
The ABaud RateB, AData LengthB, AParityB and AStop BitB settings will be automatically adjusted
according to the default values of the selected device.
When APelco-DB is selected for AControlled DeviceB, ACamera AddressB may be specified
individually for the 4 input channels.
For setting the baud rate of the serial port.
For setting the data length of the serial port.
For setting the parity bit of the serial port.
For setting the stop bit of the serial port.
For writing memo. Comments will only appear when this page is displayed, and functions of the
serial port will not be affected.
29