Details Page - JVC 4ch Network Encoder VN-E4 Instructions Manual

Settings
(continued)

5-8 Details Page

This page is for performing detailed network setting.
A
B
C
D
E
This page can be used upon access via AadminB.
Press the AOKB button to enable the new settings upon changing. If the AOKB button is pressed upon entering an invalid value, a
warning message will appear and entry will be denied. Press the ACancelB button to restore the invalid entry to the current value.
A Image DSCP
B Audio DSCP
C MTU
D Negotiation
E PPPoE
For setting the DSCP value of IP packets in which JPEG is stored. DSCP values are used in
networks that support QoS.
For setting the DSCP value of IP packets in which audio is stored. DSCP values are used in
networks that support QoS.
For setting the maximum packet size for storing JPEG. The range of set value is between 512 to
1500 for IPv4 and 1280 to 1500 for IPv6. VN-E4 will reboot when this item is changed. Operation
will be enabled after about 1 minute.
For setting the negotiation of the network. In addition, if this is set to A10HalfB, A10FullB,A100HalfB,
or A100FullB, connect VN-E4 to network switch with same setting. If connected switch is set to
autonegotiation, negotiation failure can occur. In such case, set autonegotiation to VN-E4.
VN-E4 will reboot when this item is changed. Operation will be enabled after about 1 minute.
For setting PPPoE.
VN-E4 will reboot when this item is changed. Operation will be enabled after about 1 minute. In
addition, the DHCP client function on the ABasicB page will be automatically disabled if APPPoEB
is set to AOnB.
31