Adjusting Buttons And Indicator; Test Reset; H/V Center Confirmation And Adjustment; Adjustment - Sony KDS-R60XBR2 Service Manual

3-1-4. Adjusting Buttons and Indicator

Adjustment item
up
Adjustment item
down
Initialize data
(Not stored)
User control goes
to the standerd state
(Shipping Conditions)
JUMP
VOL +
MUTING
BD/DVD
RM-YD009
FUNCTION OF KEYS ON COMMANDER
• 1 : Changes adjustment item. (item No. moves up)
• 4 : Changes adjustment item. (item No. moves down)
• 2 : Changes adjustment category.
(category moves up)
• 5 : Changes adjustment category.
(category moves down)
• 3 : Changes data value. (up)
• 6 : Changes data value. (down)
Commander Function
Button Mode
[MUTING] + [ENTER]
WRITE
- + [ENTER] READ
8 + [ENTER]
RESET

3-2. TEST RESET

The user settings can be reset to the factory default condition as
follows.
1. Service Adjustment mode. (Refer to item 3-1-1.)
It puts it into the state that "TVM Service Menu" is displayed.
(If it is after the adjustment etc., it returns it to the picture of
TVM with the JUMP key.)
2. 8 --> MUTING --> 0
The picture is muted, Test Reset is excuted, and all LED lights.
3. After turning off power, the AC plug is pulled out once, and
insert it again.
4. When turning on power, the picture of the language choice is
displayed.
POWER
Adjustment category
up
Data up
Data down
Adjustment category
down
Read data from
NVM
DISPLAY
ENTER
Description
Writes data to NVM.
Reads data from NVM.
Set the shipping condition.
– 31 –-
3-3. H/V CENTER CONFIRMATION AND AD-
JUSTMENT
Please check the picture horizontal/vertical center after the re-
placement of the following parts .
• Optical block
• Top assembly
1, Check H/V center with 480i monoscope signal in "Full "
mode .
2, If the center is shifted , adjust it with the following service items .

3-3-1. Adjustment

Note: Be sure to adjust in PAL and NTSC modes.
1. Feed PAL monoscope signal.
2. DISPLAY t 5 t VOL (+) t TV POWER
3. Picture Position Adjustment
• Press JUMP button twice to display the panel service mode.
• Select ' 1 TG'.
• By pressing '1' key, select Sub item 35 POB_ENA.
• By pressing '6' key, change data to '0'.
PANEL SERVICE
1TG
• Select 28th or 29th with pushing 1 or 4 button and adjust
with 3 or 6 button.
28 V_CENT (Vertical position)
29 H_CENT (Horizontal postion)
4. Writing data MUTE + 0
5. Feed NTSC monoscope signal.
6. Picture Position Adjustment
(Same as the item 3.)
MUTE + 0
7. Writing data
PANEL 1TG 28 V_CENT (for V center)
29 H_CENT (for H center)
H_CENT
8. After adjustment, perform TEST RESET.
(Refer to Item 3-2.)
KDS-R60XBR2/R70XBR2
RM-YD009 RM-YD009
V_CENT