Applying Configuration Changes; Code Update - Verilink NetPath 2000 Reference Manual

New Shared Secret
(PSK)
Confirm
SNMP Management
Name
Location
Contact
Community
NAT

Applying Configuration Changes

Apply
Cancel
Restore Defaults

Code Update

3-8 N e t P a t h 2 0 0 0
Sets the shared secret password for authentication. This password is case
sensitive.
Confirms the previously set shared-secret password. This character string is
case sensitive and must match the previously set shared secret.
System
The system-level configuration lets you modify the system-level networking
capabilities, including remote management via SNMP and NAT between the
Ethernet and wireless ports.
Enables SNMP.
Values: OFF, ON
Sets SNMP name.
Sets SNMP location.
Sets SNMP contact name.
Sets SNMP community delimiter.
Enables NAT between the wireless network interface and the branch router
and local management interfaces.
Values: OFF, ON
The following buttons appear at the bottom of the Configuration screen.
This button applies the configuration changes. You must apply the changes
before they will take effect. After selecting "Apply," the changes are made
and the browser will revert to the Status Display screen.
This button cancels any configuration changes. After selecting "Cancel," all
changes are canceled and the browser will show the Status Display screen.
This button will restore all configurable entries to the factory default settings.
Select "Apply" to complete this action.
To update the NetPath 2000's operating software, select the "Code Update
button. The NetPath 2000 will display the screen shown in Figure 3.5.