Table of Contents
Advertisement
Subnet Mask
DHCP Serving
Serve Range From
To
Mode
Interface
Gateway
Remote VPN Address
Gateway
Remote LAN Subnet
Net-Mask
Local LAN Subnet
Local LAN Net-Mask
PFS Mode
Key Life
Sets the address mask that delineates local subnet range. In most cases, the
factory-default range of 255.255.255.0 will suffice.
Enables DHCP. If enabled, the user must enter an IP address range to be
served.
Values: OFF, ON
Sets the first address of the connected equipment served.
Sets the last address of the connected equipment served. When combined with
"Serve Range From," determines the number of addresses served.
VPN
The VPN settings are described below.
Enables VPN to initiate or respond automatically upon usage (Normal) or
force responder mode (Listen) or initiate a tunnel (Initiate).
Values: Disabled, Normal, Listen, Initiate
Selects which interface supports VPN tunneling. Set to Wireless, unless in
Test Mode.
Values: Wireless, Local-Mgt, Router
Sets Gateway address. Leave blank when using the wireless interface since, in
this case, the Gateway is provided through the PPP link.
Sets the address of the remote VPN unit. This address must match the remote
VPN termination device.
Sets the IP address of the routable Gateway to the remote terminating VPN
device.
Sets the remote subnet address on the unencrypted remote side of the tunnel.
Sets the remote LAN net-mask to narrow the range of remote network clients
contacted.
Sets the local subnet address on the unencrypted local LAN side of the tunnel.
This address must match the router interface address described above.
Sets the local LAN net-mask to narrow the range of local network clients
connected to the tunnel.
Enables or disables the Perfect Forward Secrecy (PFS) mode.
Values: OFF, ON
Sets the PFS Key Life update period in seconds. The default is 28800
seconds.
C o n f i g u r a t i o n
3-7
Advertisement
Table of Contents
