Modify Configuration - Verilink NetPath 2000 Reference Manual

Modify Configuration

3-4 N e t P a t h 2 0 0 0
After you enter the password, a screen similar to that shown in Figure 3.3 will
appear.
The configuration information contained in this chapter assumes the use of the
local management Ethernet port.
NOTICE:
The configuration information shown in the menus below assumes the
use of the local management Ethernet port.
Figure 3.3 Sample Administration-Level Status and Configuration Screen
This screen is identical to the Status-Only access screen except for the
configuration buttons at the bottom of the screen. These buttons let you
change the NetPath 2000's configuration, software, and passwords. Each of
these buttons is described below.
The "Modify Configuration" button displays the screen shown in Figure 3.4
and lets you change the NetPath 2000's configuration.