Enterasys X-Pedition XSR-1850 Getting Started Manual page 52

Optional: Configuring Remote Auto Install
The following is a CISCO configuration at the the central site:
vpdn enable
+
Enables a virtual private dial-up network configuration on the router.
vpdn-group 1
+
Creates a VPDN session group and links it to a virtual template.
accept-dialin
protocol pppoe
virtual-template 1
pppoe limit per-mac 10
+
This is an optional command.
pppoe limit max-sessions 32000
+
This is an optional command.
interface GigabitEthernet1/0/0
no ip address
negotiation auto
!
interface GigabitEthernet1/0/0.10
encapsulation dot1Q 20
pppoe enable
pppoe max-sessions 10
+
Optional. This command enables PPPoE and allows PPPoE sessions to be created through this sub-interface.
!
interface Virtual-Template1
ip unnumbered loop 0
mtu 1492
peer default ip address pool pool1
ppp authentication pap
ip helper-address 192.168.72.118
+
This is the address of the TFTP server.
ip directed-broadcast
+
This command configures the virtual template interface.
!
ip local pool pool1 192.168.0.1 192.168.0.100
username 0000019876543210 password 0 0000019876543210
+
Enter the remote XSR's serial number.
aaa new-model
!
aaa authentication ppp default local ! look at local database first
aaa authentication ppp dialins local
+
Specifies the IP local pool to use for address assignment.
When the RAI process begins, the remote XSR displays the following messages:
**************** PRESS ANY KEY TO TERMINATE REMOTE AUTO INSTALL ***************
Phase 2 - ADSL - searching for pvc's ...Training (60 sec)
+
The XSR begins training with the DSLAM, waiting 60 seconds.
Phase 2 - ADSL - searching for pvc's ...Training (54 sec)
Phase 2 - ADSL - searching for pvc's ...
+
Training is successful, discovery of VPI/VPCs begins.
3-6 Software Configuration