Compactflash Memory Card; Led Behavior - Enterasys X-Pedition XSR-1850 Getting Started Manual

For instructions on installing the Redundant Power System, refer to the Hardware Installation
chapter on page 2‐1.

CompactFlash Memory Card

The optional plug-in CompactFlash (CF) memory card, shown in
chip controller and flash memory modules in a matchbook-sized package with a 50-pin, PCMCIA
connector consisting of two rows of 25 female contacts each.
The PCMCIA male interface supports both Type I and Type II CF cards. Note that the CF release
mechanism pops out when you install the card.
For instructions on installing the CompactFlash card, refer to the Hardware Installation chapter in
this manual.
Pin 1

LED Behavior

The ten LEDs located on the XSR front panel display system and port status as described in the
Table A-3 and illustrated in
Figure A-29 Passive Power Chassis DC Output Pinouts
DC Output
Pin 1
Pin 7
Pin 9
Pin 3
Figure A-30
Figure A-31.
Figure A-31
10/100BT
POWER SYS VPN
Cable, CompactFlash and Accessory Specifications
Pin Signal
1,2 +5.1V
4 -12V
5 +12V
3,7 COMMON
8 (+) 5.1V sense
9 (-) 5.1V sense
6 N/C
CompactFlash Memory Card
XSR LEDs
ACT 10/100BT ACT
ETHERNET ETHERNET CONSOLE NIM1
PORT 1 PORT 2
Figure A-30, comprises a single
Pin 50
NIM2
XSR Getting Started Guide A-23