Jumper And Connections - QSSC -310DA User Manual

Jumper and Connections

The following table lists jumper locations and descriptions.
Location Jumper
J7 BMC Firmware Up-
date
J4 Password Setting
CMOS Setting
The following table lists connector locations and descriptions.
Location Header Type
J18 FAN1
J21 FAN2
J17 PCI FAN
J16 Daughter board
connector
J8 IPMB
FP_CONN1 Front panel connector
J9 Fault LED
JP1 Port 80 debug
connector
J10 Intrusion switch
connector
Note:
J9 – Fault LED is not supported by the QSSC-310LA SKU.
Default Setting Function Description
Open Open: Default
1-2: BMC FW Update
1-2(Short) 1-2 (Short): Short for normal (default)
3-4(Open) 1-2 (Open): clear password
3-4 (Open): default
3-4 (Short): Clear CMOS
Function Description
Pin1: FAN_PWM
Pin2: FAN_TACH
Pin3: +12V
Pin4: GND
Pin1: FAN_PWM
Pin2: FAN_TACH
Pin3: +12V
Pin4: GND
Pin1: FAN_PWM
Pin2: FAN_TACH
Pin3: +12V
Pin4: GND
This connector is used for daughter board connection.
Pin1: SMB_DAT (5VSB)
Pin2: GND
Pin3: SMB_CLK (5VSB)
Pin4: P5V_STB
This connector is used for Front panel connector
Pin1: Fault_LED0
Pin2: Fault_LED1
Pin3: Fault_LED2
Pin4: Fault_LED3
This connector is used for debug board connector
Pin1: GND
Pin2: Intrusion pin
Pin3: NC
7
Chapter 2 — Installing Hardware