Ford LSG 875 Service Manual page 97

3-l 7 FUEL SYSTEM
3-17
MODEL 2300 2-V CARBURETOR
(Continued)
Main Body
1. Drop the accelerating pump discharge nee-
dle into the well. Seat the needle with a
brass drift and a light hammer. Make sure it
is free. Position the accelerating pump dis-
charge nozzle gasket and nozzle in the main
body; then install the attaching screw and
gasket.
2. Place the choke rod seal in the groove lo-
cated on the underside of the carburetor air
cleaner flange.
3. Working from the underside of the car-
buretor air cleaner flange, slide the choke
rod (with the small upset end of the top)
through the opening in the main body and
rod seal.
poppet valve, install the spring, spring seats,
and retainers.
5. Position the choke plate shaft in the air horn.
Position the choke rod in the choke plate
shaft lever and over the spring.
6. Position the choke plate poppet valve over
the retaining screws, then position the choke
plate on top of the poppet valve.
7. Place the spacers over the screws, then
position the flat spring over the screws so
that the curved portion is down. Install the
attaching nuts.
8. Invert the main body and position the gasket
on the main body. Place the throttle body in
position on the main body sliding the choke
rod into the choke rod lever as the throttle
4. Place the air horn poppet valve in position body is placed into position. Install the throt-
on the main body. From inside the air horn,
tle body to main body screws and
insert the pins through the main body and
lockwashers.
RETAINER
FUEL LEVEL
DIAPHRAGM
FILTER SCREEN
INLET NEEDLE
AND SEAT ASSEMBLY
ADJUSTMENT LOCK SCREW
%2732-A