Stamina 55-1532A Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
BUCKLE
1.
2.
STEP 8
Install the HEIGHT ADJUSTMENT BEAM(6) into MAIN FRAME(4) by pulling the LARGE SPRING PIN(18)
on the MAIN FRAME(4) and inserting the HEIGHT ADJUSTMENT BEAM(6) as shown. For added safety,
thread the LOCKING KNOB(19) into back side of the MAIN FRAME(4).
Do not use the Gravity Inversion Therapy Table until you have verif ied your height setting.
WARNING:
Failure to use the proper he ight setting can result in difficulty recovering from the decline position.
See HEIGHT ADJUSTMENT instructions on page 10.
STEP 9
Attach the NYLON STRAP(27) onto the BUCKLE on the end of the BUCKLE STRAP(28) by inserting the
end of the strap up through the bottom of the buckle, as shown in the illustration 1.
STEP 10
Hook the end of the NYLON STRAP(27) onto the loop on the back of the MAIN FRAME(4). Hook the end
of the BUCKLE STRAP(28) onto the loop on the FRONT FRAME(1).
NOTE: The NYLON STRAPS are used to control the de cline angle of the Gravity Inversion Thera py
Table. For a steeper decline angle, lengthen the straps. For a smaller decline angle, shorten the
straps. M ake sure the se NYLON STRAPS are tight in the buckle a nd check the de cline angle
before using the Gravity Inversion Therapy Table.
A.
B.
C.
9