Table of Contents
Advertisement
Configuring the Preinstalled Solaris 10
Operating System
After you have completed the configuration worksheet, use the following procedure
to configure the preinstalled Oracle Solaris software.
▼ Configure the Software
1. If you are not already logged in to ILOM, log in either locally from a serial
connection, or remotely over the network.
See
"Log In to ILOM Using a Serial Connection" on page 18
Using an Ethernet Connection" on page
2. If main power has not yet been applied to the server module, apply main
power.
See
"Applying Main Power to the Server Module" on page
3. From the ILOM prompt, type the following command and answer the prompt:
-> start /SP/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started.
System messages appear and then the GRUB menu (
From the GRUB menu, you can choose whether you want to continue to direct the
display to the serial port, or whether you want to redirect the display to a device
connected to the video port.
Chapter 5
Configuring the Preinstalled Solaris 10 Operating System
or
19.
26.
FIGURE 5-1
"Log In to ILOM
) is displayed.
37
Advertisement
Table of Contents
