Epson LX-300+II RTP Service Manual page 34

EPSON LX-300+II/300+II RTP/1170II

Paper_path
Table 1-37. Paper_Path
paper_path
Continuous paper (rear)
Continuous paper (bottom)
Cut sheet (rear)
CSF Single bin

characteristic status code
Table 1-38. Characteristic Status Code
location
Structure version +0
Starting date +2
Total printing line number +8
Total power on hour +16
Total printing line number
+20
for ribbon charge timing

MIB proxy information
"IG:"
"0305NA," Sheet feeder bin 1 (removable), capacity 5 mm,
quantity of paper N.A.
"09NANA," Manual feed rear, capacity N.A., quantity of paper N.A.
"0CNANA;" Tractor rear, capacity N.A., quantity of paper N.A.
"TEC:06;" 9-pin SIDM
PRODUCT DESCRIPTION
"<paper_path code>"
"0000"
"0001"
"0200"
"0100"
size type Refer to
2bytes "02" fixed
6bytes "yy", "mm", "dd" "SD" command
8bytes "nnnnnnnn" "TL" command
4bytes "nnnn" "TL" command
8bytes "nnnnnnnn" "TL" command
1.5.3.2 Packet commands
Function
Device ID request
Device ID reply * 1
State-Reply request
State-Reply * 2
Reply EEPROM data
in the specific address
request (LX-300+II)
Reply EEPROM data
in the specific address
-
request (LX-1170II)
EEPROM data reply
No support command
*1 The reply string is the same as BDC-ID Reply.
*2 The reply string is the same as BDC-ST Reply.
Control codes
Table 1-39. Packet Commands
Code
"di" 01H 00H 01H
"@EJL" SP "ID" CR LF <Device ID string> FF
"st" 01H 00H 01H
"@BDC" SP "ST" CR LF <printer status string> FF
"||" 06H 00H r1 r2 41H BEH A0H d1
r1, r2 means R code. (e.g. r1=A8, r2=5Ah)
d1 : EEPROM address (00h - FFh)
"||" 06H 00H r1 r2 41H BEH A0H d1
r1, r2 means R code. (e.g. r1=A8, r2=6Ah)
d1 : EEPROM address (00h - FFh)
"@BDC" SP "PS" CR LF "EE:" <addr> <data> ";" FF
"XX:;" FF
(XX is the command string being invalid.)
Revision D
34