Sound And Other Settings - JVC TH-M301 Instructions Manual

Advanced operations

Sound and other settings

IMPORTANT
Before using the remote control for the following
operation;
• Set the remote control mode selector to
AUDIO.
NOTE
Before you start operation;
• There is a time limit when doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
1
Press SETTING.
Example:
B A L : C E N T E R
2
Press Cursor
you want to set.
• BAL (Balance):
You can adjust the balance between the front left and front
right speakers.
• DEC (Decode):
When you play an external source (DBS is selected as a
source) that was encoded with Dolby Digital or DTS Digital
Surround, the following symptoms may occur;
• No sound comes out at the beginning of playback.
• Noise comes out while searching for or skipping chapters
or tracks.
AUT/PCM (Auto/PCM):
Normally select this. The system automatically
detects the incoming signals.
DOLBY D: Select this if the symptoms above occur when
playing a disc (or software) encoded with
Dolby Digital.
DTS: Select this if the symptoms above occur when
playing a disc (or software) encoded with DTS
Digital Surround.
37
/ to select the item
• M. OUT (Monitor Out):
Select the video output jack type by which you watch DVD
playback after connecting your TV. (
Set the video output to use AV COMPU LINK remote
control system. ( pg. 44)
VIDEO: To watch DVD playback via the VIDEO jack.
S: To watch DVD playback via the S-VIDEO jack.
COMPNT (component):
To watch DVD playback via the COMPONENT
VIDEO OUT jacks.
• DiscIll (For TH-M606/TH-M603/TH-M505/TH-M501):
When you select DVD as the source and leave the system in
stop mode for 5 minutes, the disc lamps starts illuminating.
3
Press Cursor
adjustment or selection.
Example:
B A L :
The adjustment is set and display automatically disappears a
few seconds later.
NOTE
• When "DOLBY D" or "DTS" is selected, if a signal encoded with
another digital format comes in, you cannot listen to the sound. (The
DIGITAL or indicator flashes.)
See page 26 for button locations.
pg. 14)
/ to make an
-- 5
R