Tray Lock; Sound And Other Settings - JVC TH-S3 Instructions Manual

Advancedoperations
When using the on-screen bar:
1
Press ON SCREEN twice.
Tile on-screen bar appears on the TV screen.
2
Press Cursor =.-/_ to highlight _-_OFF.
3
Press ENTER.
4
Press Cursor T/A repeatedly to select
"A-B".
5 Press ENTER at the beginning of the
part you want to repeat (point A).
6 Press ENTER at the end of the part you
want to repeat (point B).
A-B Repeat Playback starts.
7
Press ON SCREEN.
The on-screen bar disappears.
To cancel
Select "OFF" in step 4, then press ENTER.
NOTE
• When playing back a DVD VlDEO, A-B Repeat Playback is l_ossitHe
only within the same title.
• "A=B" cannot be selected during Program and Random Playback.
You can lock the tray and prohibit the unwanted disc ejection.
On the center unit ONLY:
While tile system is turned off
||
Press and hold
• The system turns on and "LOCKED" appears on the display
window.
• If you try to eject the disc, "LOCKED" appears to indicate that
the tray is locked.
To cancel
Carry out tile same operation again.
• The system turns on and "UNLOCKED" appears on the display
window.
I See page 20 for button locations. I
NOTE
• This function also takes effect for tlre sources other than DVD.
• Bel\_re you start operation:
There is a time limit when doing the l\)llowing steps. If the setting is
cancelled before you finish, start from step 1 again.
1
Press SETTING.
Example:
BAL'CENTER
L Press Cursor T/A to select the item
you want to set.
• BAL (Balance):
You can adjust the balance between the front left and front
right speakers.
• DEC (Decode):
When you play an external source (AUX DIGITAL is
selected as a source) that was encoded with Dolby Digital or
DTS Digital Surround, the following symptoms may occur:
• No sound comes out at the beginning of playback.
• Noise comes out while searching for or skipping chapters
or tracks.
AUT (Auto)/PCM:Normally select this. The system
automatically detects the incoming signals.
DOLBY D: Select this if the symptoms above occur
when playing a disc (or software) encoded
with Dolby Digital.
DTS: Select this if the symptoms above occur
when playing a disc (or software) encoded
with DTS Digital Surround.
• A. POS (Audio Position):
Set the audio position of subwoofer so that the subwoofer
level can be automatically adjusted properly. (The smaller
the number becomes, the more the level decreases
automatically when listening in stereo.)
Press Cursor =.-/_ to make an
adjustment or selection.
Example:
BAL • R -5
The adjustment display automatically disappears a few
seconds later with the current setting.
NOTE
• When "DOLBY
D' or "DTS ' is selected, ifa signal encoded with
another digital l\)rmat comes ira, you cannot listen to tire sound. (Tire
13[1D1G1TAL or _ indicator flashes.)
3O