Operation; Safety Notice; Location Of Controls - Lopi Heritage-2000 Owner's Manual

20

Safety Notice

Read this entire manual (especially the "Safety Precautions" on pages 2 and 3)
before using this stove.
damage, bodily injury, or even death.

Location of Controls

The pilot flame is located
below the rear log.
PILOT
IGNITER
Gas Control Valve
Gas Control Knob
On/Off Switch
Gas Control Knob
Flame Adjust Knob
Pilot Igniter
Blower Control
? If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off
Switch "OFF" will keep the heater off always.
Travis Industries

Operation

Failure to follow the instructions may result in property
Flame Adjust Knob
This control is used to turn the main burner on and off.
This knob is used to control gas to the heater and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of
the knob indicates the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The
pointer above the knob points to the position this knob is in.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly
next to the pilot, igniting the pilot flame.
This knob controls the speed of the internal convection blower that
pushes the heated air into the room.
9 3 5 0 8 1 2 1
ON/OFF Switch
The on/off
switch is
located on
the back of
the heater.
Blower
Control
2 3 1 0 0 0