Connecting The Satellite (Front, Centre, Surround) Speakers - JVC SP-PWR1 Instructions Manual

Connecting The Satellite (Front, Centre, Surround) Speakers

Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
TH-R1
4 16
Powered subwoofer SP-PWR1
4 m
Centre speaker SP-THS55C
The satellite speakers are equipped with their speaker cords attached directly to their speaker unit instead of
having speaker terminals on their cabinet.
TH-R3
Powered subwoofer
SP-PWR3
Front speakers
SP-THS66F
CAUTIONS:
●
When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER
IMPEDANCE) indicated near the speaker terminals on the rear of
the powered subwoofer.
●
DO NOT connect more than one speaker to one speaker
terminal.
4 m
Front speakers
SP-THS55F
10 m
4 16
4 m
Speaker cord
●
Connect the black cords to the black (G) terminals.
●
Connect the white cords to the (F) terminals
referring to the table below:
FRONT SPEAKERS (LEFT)
FRONT SPEAKERS (RIGHT)
CENTRE SPEAKER
SURROUND SPEAKERS (LEFT)
SURROUND SPEAKERS (RIGHT)
Surround speakers
SP-THS55S
Centre speaker
SP-THS66C
4 m
10 m
Precautions for daily use
●
When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
●
Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by internal
heat build-up.
●
When holding a speaker, always grasp the lower portion. (TH-R3)
●
Do not lean against the speakers, as the speakers could fall
down or break, possibly causing an injury. Especially make sure
that children do not lean against them. (TH-R3)
INSTALLING YOUR NEW UNIT
White
Black
Red
Black
Surround speakers
SP-THS66S
White
Red
Green
Blue
Grey
14