Speaker Set - JVC SP-PWR1 Instructions Manual

Speaker Set

To obtain superior sound effects, you need to perform the speaker
and subwoofer setting after all connections have been completed.
●
Turn on the unit.
●
Set the remote control selector switch to AUDIO.
●
Press DVD on the remote control.
DVD
SMART S.SET UP
Smart Surround Setup
The distance from the listening position to the speakers is one of
the important elements to obtain the best possible sound effects.
By using Smart Surround Setup, the following are automatically
calculated by one simple action^clapping hands.
●
Speaker distance (with comparison to the nearest speaker)
●
Speaker output level (except the subwoofer)
1
Take position from where you listen to the sound.
●
Make sure the speaker cables are securely connected.
2
Press and hold SMART S.SET UP until ASETTING UPB blinks
on the front display panel.
L R SW
PL
3
After confirming that ASETTING UPB stops blinking, clap your
hand over your head once while ASETTING UPB still remains lit.
●
The unit starts detecting the level of the sound coming
through each speakers (except the subwoofer).
1 2 3
4 5 6 AUDIO
TV
SAT
7 8 9
0
SETTING
Selection Keys
VOL
(FGDE)
ENTER
NOTES:
●
In order to set the speaker information effectively using the Smart
Surround Setup, the AC plug of all devices, which are potential
noise sources, connected to the unit or subwoofer should be
removed.
●
Before starting Smart Surround Setup, set the speaker
information correctly with respect to each speaker except for the
subwoofer.
●
When the setting is made using Smart Surround Setup, the
speaker distance and output level you have set before will be
invalid.
●
If you have turned off the front display panel, cancel Dimmer.
Otherwise, you cannot see the information on the front display
panel during Smart Surround Setup.
●
Smart Surround Setup may not be properly performed if the
clapping sound is blocked.
●
When you change the speakers, perform the procedures from
step 1 again.
When the clapping sound is detected successfully,
ASUCCESSFULB appears on the front display panel, and the
values set are shown as follows.
Example:
A
A Standard channel (the nearest speaker).
This speaker position now works as the reference position (0 m)
and the distance of the other speakers is shown by the
difference with this reference speaker position.
B L: Left front speaker
R: Right front speaker
C: Centre speaker
LS: Left surround speaker
RS: Right surround speaker
C Difference of each speaker position in distance (m)
D Output level (-6 dB – +6 dB) of each speaker
When the clapping sound is not detected correctly,
ASETTING UPB appears again after one of the following messages
appears. In this case, repeat step 3.
SILENT:
●
The unit detects sound from only the left and right front speakers.
●
The unit detects no sound from the front speakers and detects
sound from at least one of the other speakers.
SILENT-ALL:
●
The unit did not detect any sound from any speakers for about
12 seconds.
FAILED:
●
The unit cannot detect sound from the left or right front speaker.
When 3 consecutive detections failed,
MANUAL:
●
Smart Surround Setup ends after the message is displayed.
Perform ASetting The Speaker DistanceB (A pg. 23).
INITIAL SETTINGS
B C D
L
C R
RS LS
22