Installing Your New Unit; Connecting The Tv And Tv Antenna - JVC SP-PWR1 Instructions Manual

INSTALLING YOUR NEW UNIT

Connecting The TV And TV Antenna

To [TV ANTENNA IN]
Back of unit
IN
OUT
To [TV
To
ANTENNA
[COMPONENT
OUT]
VIDEO OUT
(Y/P
B
Component
video cable
(not supplied)
RF cable
(supplied)
To 75 ohm terminal
It's essential that your unit be properly connected.
ATTENTION:
●
Your TV must have a 21-pin AV input connector (SCART) for
the basic connection to the unit.
●
Connect the AC plug only after all connections to the TV has
been completed.
11
TV aerial cable
Mains power
LEFT
RIGHT
To [L-1 INPUT/
OUTPUT]
21-pin SCART
/P )]
R
cable
(supplied)
TV
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO
OPERATION CAN BE PERFORMED.
1
Make sure the package contains all of the accessories listed in
AACCESSORIESB (A pg. 92).
2
Place the unit on a stable, horizontal surface.
3
Connect the unit to a TV depending on the TV and cables you
use.
8 Basic Connection
To connect to a TV with 21-pin SCART input connector ^
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the [TV ANTENNA IN] connector
on the rear panel of the unit.
C Connect the [TV ANTENNA OUT] connector on the rear panel
Mains outlet
of the unit and the TV's aerial connector with the supplied RF
cable.
D Connect the [L-1 INPUT/OUTPUT] connector on the rear panel
cord
of the unit and the TV's 21-pin SCART connector with a
supplied 21-pin SCART cable.
●
The [L-1 INPUT/OUTPUT] connector accepts and delivers
either a composite signal (regular video signal), Y/C signal or
RGB signal.
●
Set your TV to the VIDEO, Y/C, or RGB mode according to the
type of your TV's SCART connector.
8 Component Video Connection
To [AUDIO
To connect to TV's component video input connectors ^
OUTPUT]
A Perform steps A - C of ABasic ConnectionB.
B Connect the unit's [COMPONENT VIDEO OUT (Y/P
connectors to the TV's component video input connectors.
C Connect the unit's [AUDIO OUTPUT] connectors to the TV's
AUDIO input connectors.
●
Audio
You can obtain high-quality component video pictures.
cable
●
By using the component video connection, you can view the
(not
images in the progressive mode. For switching to the
supplied)
progressive mode, refer to AScan Mode SetB (A pg. 77).
NOTES:
●
Select an appropriate option of AL-1 OUTPUTB as follows
(A pg. 69):
When your TV's SCART
connector accepts:
Composite signals
Y/C signal (separated
luminance (brightness) and
chrominance (colour) signals)
RGB signal
Component video signal
When the setting selected is not in accordance with the TV
connected and depending on the type of appliance connected to
the unit, the correct picture will not appear.
●
If you possess a satellite receiver, refer to AConnecting To A
Satellite ReceiverB as well. (A pg. 71)
●
Connecting the FM and AM antennas (A pg. 12)
●
Connecting the satellite speakers (A pg. 14)
●
Connecting the powered subwoofer (A pg. 16)
●
Connecting the power cord (A pg. 16)
/P )]
B R
Set AL-1 OUTPUTB to:
ASCART VIDEOB
ASCART S-VIDEOB
ASCART RGBB
ACOMPONENTB