Remote Loading; Using Ftp - Huawei Quidway S3026C-PWR Installation Manual

Installation Manual
Quidway S3026C-PWR Ethernet Switch
III. Loading host software
Step 1: Choose option 1 in the Boot menu and the system prompts:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
Choose the desired protocol to load host software.
The subsequent steps are the same as those for loading Boot ROM, only the
system change the Boot ROM to host software in the prompts.

5.3 Remote Loading

You can also connect a user terminal over the network to the switch for remote
loading of Boot ROM and host software.

5.3.1 Using FTP

Run the FTP server on the local PC, configure FTP username and password, and
specify a file directory (suppose the IP address is 10.10.110.1). Log into the switch
using Telnet and transfer host software to the switch using FTP.
Assume the host software file is SWITCH.app and Boot ROM file is SWITCH.btm.
Follow these steps to load the files after logging into the switch.
Step 1: Download the files to the switch using FTP.
<Quidway> ftp 10.10.110.1
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):lyt
331 Give me your password, please
Password:
230 Logged in successfully
[ftp] get SWITCH.app SWITCH.app
[ftp] get SWITCH.btm SWITCH.btm
[ftp] bye
Step 2: Load Boot ROM.
Chapter 5 Loading BOOTROM and Host Software
Huawei Technologies Proprietary
5-11