Removing Optional Interface Modules - Huawei Quidway S3026C-PWR Installation Manual

Installation Manual
Quidway S3026C-PWR Ethernet Switch
Caution:
Before performing any of the following operation, please make sure that the switch is powered off to
avoid the damage to the components.
Step 1: Wear ESD wrist strap and disconnect the power off the switch.
Step 2: Remove the blank filler panel in the module slot.
Step 3: Align the remote edge of the interface card with the hatch edge of the switch
bottom.
Step 4: Push the interface card gently into the switch until the card touches the
switch panel.
Step 5: Fix the interface card in the switch with the captive screws.
Caution:
Save the removed blank filler panel for future use.

3.4.2 Removing Optional Interface Modules

Step 1: Wear ESD wrist strap and disconnect the power off the switch.
Step 2: Use the flat-blade screwdriver to unscrew the captive screws at the both
sides of the interface module.
Step 3: Pull the card towards the operator until the interface card is completely apart
from the switch bottom.
Huawei Technologies Proprietary
3-9
Chapter 3 Installation