Lts 225-250 Series - Joining Of Body Sections - Space-Ray LTU SERIES Installation And Operation Instructions Manual

11.1) LTS 225-250 SERIES — JOINING OF BODY SECTIONS
The control box must be attached to a 6-hole flange on the 10 ft. Starting Body Package (this body package has a 6-hole
flange at both ends of the tube). The other 6-hole flange must be connected to a 24-hole flange on the body package for
LTS225-250models. The ¼-20 screws and locknuts and flange gasket required to attach these two body packages together
are included in the Body Fastener Kit of the Starting Body Package. Join the two body packages together as indicated on the
next page:
1. Join the tube flanges of the body sections together with the gasket in between. Loosely attach the heater body sections
together with the ¼-20 screws and locknuts provided. DO NOT fully tighten the screws and locknuts yet!
2. Tighten the screws and locknuts using the sequence shown. The screws and locknuts should be tightened a little bit at a
time (the same way you would secure the lug nuts to a car wheel).
3. The remaining body section joints are coupled with a compression coupling. Refer to the previous instructions for the
LTS40-250 models for installation of these couplings.
Form #43155260
Mar–05
COUPLING
(side view)
–21–