Lts 40-250 Series - Typical Layouts - Space-Ray LTU SERIES Installation And Operation Instructions Manual

9.0) LTS 40-250 SERIES — TYPICAL LAYOUTS
Straight U Shape
L Shape Z Shape
EMITTER LENGTH
MODEL
Min.
LTS 40 15 Ft.
LTS 50 15 Ft.
LTS 60 20 Ft.
LTS 75 20 Ft.
LTS 80 30 Ft.
LTS 90 30 Ft.
LTS 100 30 Ft.
LTS 110 30 Ft.
LTS 120 30 Ft.
LTS 125 30 Ft.
LTS 130 30 Ft.
LTS 140 40 Ft.
LTS 150 40 Ft.
LTS 160 40 Ft.
LTS 175 40 Ft.
LTS 180 50 Ft.
LTS 200 50 Ft.
LTS 225 50 Ft.
LTS 250 50 Ft.
NOTES:
1) In all configurations, the control unit must be connected directly to either a) the 24-hole flange of the 10 ft. aluminized
steel start/end body section (for LTS 40-200 models) or b) the 6-hole flange of the 10 ft. Alumi-Therm starting body
section (for LTS225 and LTS250 models). Failure to attach the control box to the 6-hole flange for LTS225-250 as
indicated above will void the manufacturer's warranty.
2) Joining of two 90º elbows directly together to form a "Z" shape IS NOT permitted.
3) 5 Ft. Body Packages may be utilized on any of these heaters to yield heater lengths from 50 ft. to 80 ft.
4) Any configuration of components not shown in the illustrations may be used except as noted in 1 and 2 above.
Max.
20 Ft.
30 Ft.
30 Ft.
30 Ft.
40 Ft.
40 Ft.
40 Ft.
40 Ft.
40 Ft.
50 Ft.
50 Ft.
50 Ft.
50 Ft.
50 Ft.
50 Ft.
80 Ft.
80 Ft.
80 Ft.
80 Ft.
LEGEND
–18–
Form #43155260
Mar–05