Table of Contents
Advertisement
Controls and Operations
Electronic Manual
Override
Manually retract
room
Norco slide system
(37KT only)
66
1. Locate the circuit board.
2. Press the "mode button" six times quickly, then press a seventh time and hold for
approximately five seconds.
3. The red and green LED lights will begin to flash, confirming the override mode.
4. Release mode button.
5. Back inside coach; use the normal slide control switch to retract the room.
1. Locate the control board.
2. Unplug both motors from control board.
3. The room may now be pushed in or out as desired.
Larger rooms may require several people to push.
4. Try to keep both sides of the room even.
5. When room is completely in, plug both motors back
into the control board. This applies the brake for
the motors and will keep the room locked in
posistion while the unit is traveling down the road.
CAUTION
CAUTION
CAUTION
Note: BEFORE EXTENDING OR RETRACTING SLIDE OUT ROOM: Be
sure that the driver's seat is in the forward position and the seat-back is
straight up. Slide out room will contact chair if chair is improperly positioned.
DO NOT MOVE THE Motorhome UNLESS THE MOTORS
ARE PLUGGED IN.
If you are unable to move the room after following the
above procedure, then both motors will need to be
disengaged.
Keep people and obstructions clear of room when
operating.
Operating the room with any room locking devices in
place can cause personal injury and vehicle damage. It
is the operator's responsibility to ensure that all room
locking devices (if equipped) are disengaged before
operating the room.
The motorhome must be level before extending the slide
out room(s). Failure to do so may result in structural
damage to the motorhome or water intrusion.
Advertisement
Table of Contents
