Table of Contents
Advertisement
Controls and Operations
SLIDE OUTS
Extending the room
To Retract Slide Out
InWall Slide Out
64
Refer to the manufacturer's operation's manual for complete details and
troubleshooting guide.
Keep people and obstructions clear of room when
operating.
CAUTION
CAUTION
Note: BEFORE EXTENDING OR RETRACTING SLIDE OUT ROOM: Be
sure that the driver's seat is in the forward position and the seat-back is
straight up. Slide out room will contact chair if chair is improperly positioned.
Note: Make sure that there is adequate clearance to fully extend the room.
1.
Apply the parking brake
2.
Make sure ignition is in OFF position.
3.
To extend the room, press and hold the ROOM CONTROL
SWITCH in the "OUT" position. When the room is fully
extended, release the ROOM CONTROL SWITCH.
Note:
Releasing the ROOM CONTROL SWITCH will halt the operation of
the room.
1. Make sure to clear any obstruction in the slide-out area, and set
the parking brake.
2. To retract the room, press and hold the ROOM CONTROL SWITCH in
the "IN" position. When the room is fully retracted, release the ROOM
CONTROL SWITCH.
3. Install the room locking devices if equipped.
4. If the room will not retract, refer to the "Manual Retract Procedure".
Note: The Schwintek Slide outs are designed to be operated to full extension
or full retraction during any one use. Partial extension or retraction of the room
may result in the slideout motors losing synchronous operation causing the
slide to bind and stop prior to full extension or retraction during subsequent
usage.
When extending or retracting the slide out room, the switch should be held for 3-5
seconds after the slide out box stops extending or retracting. You will be able to hear
the motors amp out. The switch needs to be held for 3-5 seconds even after the
motors amp out.
Operating the room with any room locking devices in
place can cause personal injury and vehicle damage. It
is the operator's responsibility to ensure that all room
locking devices (if equipped) are disengaged before
operating the room.
The motorhome must be level before extending the slide
out room(s). Failure to do so may result in structural
damage to the motorhome or water intrusion.
Keep people and obstructions clear of room when
operating.
Advertisement
Table of Contents
