Table of Contents
Advertisement
OPERATING THE SET-TOP (cont.)
Using the remote control
The cable TV service-provider determines the digital channels, services and screen information that you see on the TV when you use the
set-top and its remote control.
Consult the information supplied by the cable service-provider for details on how to make the most of the digital cable services. Also read
the operating instructions that are supplied with the remote control.
Activating baseband loopthrough for a DVD or similar equipment
To activate baseband loopthrough, turn off the set-top by pressing the POWER button on the remote (making sure the remote control
is set to control the set-top) or by pressing the power button on the front panel. When the set-top is turned off, the light next to the
power button is red.
If you activate baseband loopthrough, the following occur:
COMPONENT VIDEO IN
VIDEO IN
AUDIO IN
DIGITAL AUDIO IN
OPTICAL AUDIO IN
Lightning storms
Disconnect the set-top's power cord during lightning storms. A lightning storm may affect the set-top, if it is on during the storm. It may
appear that it has stopped working, but you can easily restore its operation as follows.
Unplug the set-top's power cord at the wall AC outlet. Then plug this power cord in again at the wall AC outlet (and, if there is a switch by
this outlet, switch it to its ON position).
loops through to
COMPONENT VIDEO OUT
loops through to
VIDEO OUT
loops through to
PRIMARY AUDIO OUT and
SECONDARY AUDIO OUT
loops through to
DIGITAL AUDIO OUT
loops through to
OPTICAL AUDIO OUT
Hide quick links:
Advertisement
Table of Contents
