Safety Information - Pace TDC779X Service And Installation Manual

SAFETY INFORMATION

This digital set-top has been manufactured and tested with your
safety in mind. However, improper use can result in potential
electric shock or fire hazards. To avoid defeating the safeguards that
have been built into the set-top, please observe the precautions
discussed in this document.
Warnings on the set-top
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrowhead symbol, within a
triangle, is intended to alert you to the presence of
uninsulated "dangerous" voltages within the set-top's
enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within a triangle is intended to
alert you to the presence of important instructions in
the literature accompanying the set-top.
Other warnings
To reduce the risk of electric shock, do not remove the cover of
the set-top. There are no user-serviceable parts inside it.
Do not perform any servicing unless you are qualified to do so.
Refer all servicing to qualified service personnel. Servicing the

set-top yourself will invalidate the warranty.
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
To reduce the risk of fire or electric shock, do not expose this
set-top to rain or moisture.
On the rear panel of the set-top there is a tamper-evident label that
states 'Warranty void if broken or removed'.
To avoid possible damage to the internal hard disk, do not pick up
or move the set-top while it is connected to the wall AC outlet. If
you want to move the set-top, first stop any recording, then turn off
the set-top and wait 60 seconds before disconnecting it. You should
handle the set-top carefully, as any damage you cause to the internal
hard disk (or any other component) will invalidate the warranty.
Installation
The installation of the set-top should be carried out by a qualified
installer and should conform to local codes.
Note to the installer
This reminder is provided to call the attention of the cable-TV-system
installer to Section 820-40 of the National Electrical Code (USA), which
provides guidelines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as is practical.
Service address:
Pace Micro Technology (Support Services) Ltd.
3701 FAU Boulevard, Suite 200, Boca Raton
Florida, 33431, U.S.A.