Pace TDC779X Service And Installation Manual page 8

SAFETY INFORMATION (cont.)
Safety aspects of connections
Full details of the rear panel are on page 10.
Connecting
Do not connect the set-top (or any other equipment such as a TV
or VCR) to the power supply until you have properly connected all
the other cables.
The set-top operates with a 120 V AC, 60 Hz power supply.
Do not connect the set-top to any supply other than this.
This set-top is equipped with a two-wire power cord, with a
polarized plug at one end. The other end of the cord is fitted with a
polarized connector, which is shaped such that it can be fitted only
one way into the power input jack of the set-top. Connect this end
first, before inserting the polarized plug into the wall socket-outlet.
Disconnecting
Disconnect the set-top from the power supply before you
disconnect any other equipment from its rear panel.
The only way to disconnect the set-top from the power supply is
to remove the power cord from the wall socket-outlet. The set-top
must therefore be installed near to the wall socket-outlet, which
should be easily accessible.

The POWER OUTLET plug is designed only for connection to the
AC power cord for a TV. The maximum power it can supply is 500 watts.
Do not connect any equipment that uses more than 500 watts, or any
non-TV equipment such as a toaster or hair dryer.
The CABLE IN connector is designed for
connection to a cable network only.
You must not connect any other equipment,
such as a VCR, to this input
POWER INPUT