Pace TDC779X Service And Installation Manual page 25

About Setup D: Adding a home theater receiver to Setup C
All of the points mentioned in Setup C apply.
• To enhance the sound, connect a home theater receiver.
• There is a choice of two S/PDIF outputs: (i) electrical (labeled DIGITAL AUDIO OUT, which is shown connected by cable 8 in the
diagram, opposite) and (ii) optical (labeled OPTICAL AUDIO OUT).
• When you add a home theater receiver, the set-top's audio connection to the TV (via HDMI) is not needed, so you may wish to mute
(turn off) the audio on the TV.
• Instead of the VCR's baseband audio output going to the TV, it connects via cables 7 to the home theater receiver.
• When the set-top is turned off, there are the following audio loopthroughs, which allow you to connect additional equipment to the
home theater receiver:
DIGITAL AUDIO IN loops through to
OPTICAL AUDIO IN loops through to
AUDIO IN loops through to
AUDIO IN loops through to
Cable Wiring Diagram D
Cable TV
TDC779X
RF Cable TV
RF
Recorder
DIGITAL AUDIO OUT
OPTICAL AUDIO OUT
PRIMARY AUDIO OUT
SECONDARY AUDIO OUT
HDMI or [DVI & Audio]
set-top
Digital Audio
Home
Theater
Stereo Audio
VHS
Audio & Video
CONNECTING THE EQUIPMENT (cont.)
HDTV