Getting Started; Putting Connection Server In Run - iNels Connection server Installation Manual

1. Getting started

Commands are given in purple, e.g.:

 Paths and links are given in red:
 Notices are given in orange:
terminal
 Tips and tricks are given in green: You do not want to run configuration via iMM CC at
every server separately; as long as they are more, iMM CC can be enabled from any
PC connected to local network...
 Commands are in italic
Important configuration commands in Linux:
- finding IP address of station/server, similar to IPCONFIG in Windows
Ifconfig
– command for connection of certain device CD-ROM, network drive, etc.)
mount
- command for disconnection of certain device
umount
1.1.

Putting Connection Server in run

a) Once you unpack Connection server, let the device stabilize at room temperature.
b) Insert attached SD card in the slot.
c) Connect the cabling (do not connect the supply yet):
 Display HDMI device
 LAN cable for ethernet port!
 Keyboard to USB port.
d) After connecting the power supply (adapter with micro USB connector), Connection
Server will start automatically.
e) When starting the system you can watch opening of individual services on the
screen. Some services do not open, and display FAILD in red; in majority of cases it
is not a problem; and has no influence whatsoever on the run of Connection Server.
f) When start of services is completed, only one line requiring login name will appear on
the screen.
No characters display when writing a password in terminal
Verze 02‐ 039/2011 Rev.:091013
Connection Server Installation Manual
sudo reboot
imm/Pictures
No characters display when writing a password in
Alarmpi login: imm
Password: imm123
Stránka 3 z 31