Table of Contents
Advertisement
38
8. Attach the face following the directions below (see the directions included with the face for full
details).
Face Installation and Removal
The face has hooks that hold it in place. Make sure the face locks in place when installing.
PLATED SURFACES:
Make sure the plated surfaces are clean
before starting the fireplace. Any marks
left on plated surfaces may become
etched in place. Clean plated surfaces
with denatured alcohol and a soft cloth.
ACID WASH WARNING: Before installing the faceplate, make sure any masonry that has been
treated with acid wash has been properly neutralized (this is used primarily with brick faces). Acid
wash (muriatic acid) is used to remove excess mortar. If not properly neutralized with an ammonia
solution, the gold face may develop a permanent tarnish when the acid evaporates over time.
Contact your dealer if uncertain your facing has been properly neutralized.
9. Turn the flame adjust knob to its highest position - the flames should be approximately 10" tall.
Check the flame on low position. The flames should burn off of each burner hole. If the heater
does not work correctly, contact your dealer for a remedy.
10. Give this manual to the home owner and fully explain the operation of this heater.
© Travis Industries
Finalizing the Installation
Lift and rotate the face forward
until the top brackets lock into the
upper slots.
4040927
b
a
Tilt the face back
and insert the
bottom brackets
into the lower
slots until they
lock in place.
100-01158
Advertisement
Table of Contents
